Cisco Catalyst 4500 Series Configuration Manual page 781

Chapter 2
show hw-module uplink
To display the current uplink mode, use the show hw-module uplink command.
Command Default
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.2(25)EW
Usage Guidelines
If the active uplink mode is different than configured mode, the output displays the change.
By default, the current (operational) uplink selection is displayed.
Examples The following example shows the output displaying the current (active) uplinks:
Switch# show hw-module uplink
Active uplink configuration is TenGigabitEthernet
The following example shows the output for redundant systems in SSO mode if the 10-Gigabit Ethernet
uplinks are active, and the Gigabit Ethernet uplinks are selected:
Switch# show hw-module uplink
Active uplink configuration is TenGigabitEthernet
(will be GigabitEthernet after next reload)
A 'redundancy reload shelf' or power-cycle of chassis is required to
apply the new configuration
The following example shows the output for redundant systems in RPR mode if the 10-Gigabit Ethernet
uplinks are active, and the Gigabit Ethernet uplinks are selected:
Switch# show hw-module uplink
Active uplink configuration is TenGigabitEthernet
(will be GigabitEthernet after next reload)
A reload of active supervisor is required to apply the new configuration.
Related Commands Command
hw-module uplink select
show hw-module uplink
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Selects the 10-Gigabit Ethernet or Gigabit Ethernet uplinks
on the Supervisor Engine V-10GE within the W-C4510R
chassis.
show hw-module uplink
2-733