Cisco Catalyst 4500 Series Configuration Manual page 180

cos (netflow-lite exporter submode)
cos (netflow-lite exporter submode)
NetFlow-lite is supported only on Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
Note
To specify a CoS value for the NetFlow-lite collector, use the cos command. To delete the value, use the
no form of this command.
Syntax Description
cos-value
Command Default 0
Command Modes netflow-lite exporter submode
Command History Release
15.0(2)SG
Usage Guidelines This option allows you to set the CoS value of VLAN tags for packet samples exported by the fpga alone.
Examples The following example shows how to specify a CoS value for the NetFlow-lite collector:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-142
cos cos-value
no cos cos-value
Specifies a CoS value for the NetFlow-lite collector. Valid values from 0 to 7.
Modification
This command was introduced on the Catalyst 4948E and Catalyst 4948E-F
Ethernet switches.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-30934-01