Cisco Catalyst 4500 Series Configuration Manual page 469

Chapter 2
logging event trunk-status (interface configuration)
To enable the trunk-status event messaging on an interface, use the logging event trunk-status
command. Use the no form of this command to disable the trunk-status event messaging. Use the
logging event trunk-status use-global command to apply the global trunk-status setting.
Command Default
Global trunk-status messaging is enabled.
Command Modes Interface configuration mode
Command History Release
12.2(25)SG
Usage Guidelines
To enable system logging of interface state-change events on a specific interface, enter the
logging event trunk-status command in interface configuration mode.
To enable system logging of interface state-change events on all interfaces in the system, enter the
logging event trunk-status use-global command in global configuration mode. All interfaces without
the state change event configuration use the global setting.
Examples
The following example shows how to enable logging event state-change events on interface gi11/1:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# interface gi11/1
Switch(config-if)# logging event trunk-status
Switch(config-if)# end
Switch#
The following example shows how to turn off logging event trunk status regardless of the global setting:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# interface gi11/1
Switch(config-if)# no logging event trunk-status
Switch(config-if)# end
Switch#
logging event trunk-status
no logging event trunk-status
logging event trunk-status use-global
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
logging event trunk-status (interface configuration)
End with CNTL/Z.
End with CNTL/Z.
2-429