Debug Ip Dhcp Snooping Event - Cisco Catalyst 4500 Series Configuration Manual
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
debug ip dhcp snooping event
To debug the DHCP snooping events, use the debug ip dhcp snooping event command. To disable
debugging output, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
Debugging of snooping event is disabled.
Command Modes
Privileged EXEC mode
Command History
Release
12.1(12c)EW
Examples
The following example shows how to enable the debugging for the DHCP snooping events:
Switch# debug ip dhcp snooping event
Switch#
The following example shows how to disable the debugging for the DHCP snooping events:
Switch# no debug ip dhcp snooping event
Switch#
Related Commands
Command
debug ip dhcp snooping
packet
debug ip dhcp snooping event
no debug ip dhcp snooping event
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Debugs the DHCP snooping messages.
debug ip dhcp snooping event
2-163
Advertisement
Table of Contents
