Show Diagnostic Result Module Test 3 - Cisco Catalyst 4500 Series Configuration Manual

show diagnostic result module test 3

show diagnostic result module test 3
To display the results from the ongoing packet memory test, use the show diagnostic result module
test 3 command. The output indicates whether the test passed, failed, or was not run.
Syntax Description N
detail
Command Default Non-detailed results.
Command Modes EXEC mode
Command History Release
12.2(18)EW
Usage Guidelines The detail keyword is intended for use by Cisco support personnel when analyzing failures.
Examples The following example shows how to display the results from the ongoing packet memory tests:
Switch# show diagnostic result module 1 test 3
Test results: (. = Pass, F = Fail, U = Untested)
The following example shows how to display the detailed results from the ongoing packet memory tests:
Switch# show diagnostic result module 1 test 3 detail
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
packet buffers on free list: 64557 bad: 0 used for ongoing tests: 979
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-708
show diagnostic result module N test 3 [detail]
Modification
This command was introduced on the Catalyst 4500 series switch.
3) packet-memory-ongoing -----------> .
3) packet-memory-ongoing -----------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 0
Last test execution time ----> n/a
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> n/a
Total failure count ---------> 0
Consecutive failure count ---> 0
Module number.
(Optional) Specifies the display of detailed information for analysis.
Chapter 2
OL-30934-01