Cisco Catalyst 4500 Series Configuration Manual page 466

logging event link-status (interface configuration)
logging event link-status (interface configuration)
To enable the link-status event messaging on an interface, use the logging event link-status command.
Use the no form of this command to disable link-status event messaging. Use the
logging event link-status use-global command to apply the global link-status setting.
Command Default
Global link-status messaging is enabled.
Command Modes Interface configuration mode
Command History Release
12.2(25)SG
Usage Guidelines
To enable system logging of interface state-change events on a specific interface, enter the
logging event link-status command in interface configuration mode.
To enable system logging of interface state-change events on all interfaces in the system, enter the
logging event link-status global command in global configuration mode. All interfaces without the
state change event configuration use the global setting.
Examples
The following example shows how to enable logging event state-change events on interface gi11/1:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# interface gi11/1
Switch(config-if)# logging event link-status
Switch(config-if)# end
Switch#
The following example shows how to turn off logging event link status regardless of the global setting:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# interface gi11/1
Switch(config-if)# no logging event link-status
Switch(config-if)# end
Switch#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-426
logging event link-status
no logging event link-status
logging event link-status use-global
Modification
This command was introduced on the Catalyst 4500 series switch.
End with CNTL/Z.
End with CNTL/Z.
Chapter 2