Cisco Catalyst 4500 Series Configuration Manual page 270

dot1x max-reauth-req
dot1x max-reauth-req
To set the maximum number of times that the switch will retransmit an EAP-Request/Identity frame to
the client before restarting the authentication process, use the dot1x max-reauth-req command. To
return to the default setting, use the no form of this command.
Syntax Description
count
Command Default
The switch sends a maximum of two retransmissions.
Command Modes Interface configuration mode
Command History Release
12.1(19)EW
Usage Guidelines
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers. This
setting impacts the wait before a non-dot1x-capable client is admitted to the guest VLAN, if one is
configured.
You can verify your settings by entering the show dot1x privileged EXEC command.
Examples The following example shows how to set 5 as the number of times that the switch retransmits an
EAP-Request/Identity frame before restarting the authentication process:
Switch(config-if)# dot1x max-reauth-req 5
Switch(config-if)#
Related Commands Command
show dot1x
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-232
dot1x max-reauth-req count
no dot1x max-reauth-req
Number of times that the switch retransmits EAP-Request/Identity frames before
restarting the authentication process; valid values are from 1 to 10.
Modification
This command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Displays dot1x information.
OL-30934-01