Cisco Catalyst 4500 Series Configuration Manual page 59

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
arp access-list
To define an ARP access list or add clauses at the end of a predefined list, use the arp access-list
command.
Syntax Description name
Command Default
This command has no default settings.
Command Modes Global configuration mode
Command History Release
12.1(19)EW
Examples
The following example shows how to define an ARP access list named static-hosts:
Switch(config)# arp access-list static-hosts
Switch(config)#
Related Commands Command
deny
ip arp inspection filter vlan
permit
arp access-list name
Specifies the access control list name.
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Denies an ARP packet based on matches against the DHCP
bindings.
Permits ARPs from hosts that are configured for static IP when
DAI is enabled and to define an ARP access list and applies it to
a VLAN.
Permits an ARP packet based on matches against the DHCP
bindings.
arp access-list
2-21