Cisco Catalyst 4500 Series Configuration Manual page 967

Chapter 2
show policy-map control-plane
To display the configuration either of a class or of all classes for the policy map of a control plane, use
the show policy-map control-plane command.
Syntax Description input
class class-name
Command Default This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.2(31)SG
Usage Guidelines This command is not supported on Supervisor Engine 6-E, Supervisor Engine 6L-E, Catalyst 4900M,
Catalyst 4948E, and Catalyst 4948E-F.
The show policy-map control-plane command displays information for aggregate control-plane
services that control the number or rate of packets that are going to the process level.
Examples The following example shows that the policy map TEST is associated with the control plane. This policy
map polices traffic that matches the class-map TEST, while allowing all other traffic (that matches the
class-map class-default) to go through as is.
Switch# show policy-map control-plane
Control Plane
Service-policy input: system-cpp-policy
show policy-map control-plane [input [class class-name] | [class class-name]]
(Optional) Displays statistics for the attached input policy.
(Optional) Displays the name of the class.
Modification
This command was introduced on the Catalyst 4500 series switch.
Class-map: system-cpp-eapol (match-all)
0 packets
Match: access-group name system-cpp-eapol
Class-map: system-cpp-bpdu-range (match-all)
0 packets
Match: access-group name system-cpp-bpdu-range
Class-map: system-cpp-cdp (match-all)
28 packets
Match: access-group name system-cpp-cdp
police: Per-interface
Conform: 530 bytes Exceed: 0 bytes
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Table 2-39 describes the fields shown in the display.
show policy-map control-plane
2-919