Cisco Catalyst 4500 Series Configuration Manual page 116

bandwidth
•
•
Examples
The following example shows how to set the minimum bandwidth to 2000 kbps for a class called
silver-class. The class already exists in the switch configuration:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# policy-map polmap6
Switch(config-pmap)# class silver-class
Switch(config-pmap-c)# bandwidth 2000
Switch(config-pmap-c)# end
The following example shows how to guarantee 30 percent of the bandwidth for class1 and 25 percent
of the bandwidth for class2 when CBWFQ is configured. A policy map with two classes is created and
is then attached to a physical port:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# policy-map policy1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# bandwidth percent 50
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class2
Switch(config-pmap-c)# bandwidth percent 25
Switch(config-pmap-c)# exit
Switch(config-pmap)# end
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# service-policy input policy1
Switch(config-if)# end
The following example shows how bandwidth is guaranteed if low-latency queueing (LLQ) and
bandwidth are configured. In this example, LLQ is enabled in a class called voice1.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# policy-map policy1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# bandwidth remaining percent 50
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class2
Switch(config-pmap-c)# bandwidth remaining percent 25
Switch(config-pmap-c)# exit
Switch(config-pmap)# class voice1
Switch(config-pmap-c)# priority
Switch(config-pmap-c)# exit
Switch(config-pmap)# end
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# service-policy output policy1
Switch(config-if)# end
You can verify your settings by entering the show policy-map privileged EXEC command.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-78
The amount of bandwidth configured should be large enough to accommodate Layer 2 overhead.
A policy map can have all the class bandwidths specified in either kbps or in percentages, but not a
mix of both.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-30934-01