Cisco Catalyst 4500 Series Configuration Manual page 468

logging event trunk-status global (global configuration)
logging event trunk-status global (global configuration)
To enable the trunk-status event messaging globally, use the logging event trunk-status global
command. Use the no form of this command to disable trunk-status event messaging.
Syntax Description
This command has no arguments or keywords.
Command Default Global trunk-status messaging is disabled.
Command Modes Global configuration mode
Command History Release
12.2(25)SG
Usage Guidelines If trunk-status logging event is not configured at the interface level, the global trunk-status setting takes
effect for each interface.
Examples The following example shows how to globally enable link status messaging on each interface:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# logging event trunk-status global
Switch(config)# end
Switch#
Related Commands Command
logging event trunk-status global
(global configuration)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-428
logging event trunk-status global
no logging event trunk-status global
Modification
This command was introduced on the Catalyst 4500 series switch.
End with CNTL/Z.
Description
Enables the trunk-status event messaging on an interface.
Chapter 2