Cisco Catalyst 4500 Series Configuration Manual page 600

port-channel load-balance
port-channel load-balance
To set the load-distribution method among the ports in the bundle, use the port-channel load-balance
command. To reset the load distribution to the default, use the no form of this command.
Syntax Description
method
Command Default
Load distribution on the source XOR destination IP address is enabled.
Command Modes Global configuration mode
Command History Release
12.1(8a)EW
Usage Guidelines The following values are valid for the load-distribution method:
•
•
•
•
•
•
•
•
•
Examples
The following example shows how to set the load-distribution method to the destination IP address:
Switch(config)# port-channel load-balance dst-ip
Switch(config)#
The following example shows how to set the load-distribution method to the source XOR destination IP
address:
Switch(config)# port-channel load-balance src-dst-port
Switch(config)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-560
port-channel load-balance method
no port-channel load-balance
Specifies the load distribution method. See the "Usage Guidelines" section for more
information.
Modification
This command was introduced on the Catalyst 4500 series switch.
dst-ip—Load distribution on the destination IP address
dst-mac—Load distribution on the destination MAC address
dst-port—Load distribution on the destination TCP/UDP port
src-dst-ip—Load distribution on the source XOR destination IP address
src-dst-mac—Load distribution on the source XOR destination MAC address
src-dst-port—Load distribution on the source XOR destination TCP/UDP port
src-ip—Load distribution on the source IP address
src-mac—Load distribution on the source MAC address
src-port—Load distribution on the source port
Chapter 2