Cisco Catalyst 4500 Series Configuration Manual page 579
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
pagp port-priority
To select a port in hot standby mode, use the pagp port-priority command. To return to the default
value, use the no form of this command.
Syntax Description
priority
Command Default
Port priority is set to 128.
Command Modes
Interface configuration mode
Command History
Release
12.1(8a)EW
Usage Guidelines
The higher the priority, the better the chances are that the port will be selected in the hot standby mode.
Examples
The following example shows how to set the port priority:
Switch(config-if)# pagp port-priority 45
Switch(config-if)#
Related Commands
Command
pagp learn-method
show pagp
pagp port-priority priority
no pagp port-priority
Port priority number; valid values are from 1 to 255.
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Learns the input interface of the incoming packets.
Displays information about the port channel.
pagp port-priority
2-539
Advertisement
Table of Contents
