Cisco Catalyst 4500 Series Configuration Manual page 592
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
police rate
police rate
To configure single or dual rate policer, use the police rate command in policy-map configuration mode.
To remove traffic policing from the configuration, use the no form of this command.
Syntax for Bytes Per Second
Syntax for Percent
Syntax Description
units
bps
burst burst-in-bytes
bytes
peak-rate
peak-rate-in-bps bps
peak-burst
peak-burst-in-bytes
bytes
percent
percentage
burst ms ms
peak-rate percent
percentage
peak-burst ms ms
Command Default
This command is disabled by default.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-552
police rate units bps [burst burst-in-bytes bytes] [peak-rate peak-rate-in-bps bps] [pack-burst
peak-burst-in-bytes bytes]
no police rate units bps [burst burst-in-bytes bytes] [peak-rate peak-rate-in-bps bps]
[pack-burst peak-burst-in-bytes bytes]
police rate percent percentage [burst ms ms] [peak-rate percent percentage] [pack-burst ms ms]
no police rate percent percentage [burst ms ms] [peak-rate percent percentage] [pack-burst ms
ms]
Specifies the traffic police rate in bits per second. Valid range is 32,000 to
32,000,000,000.
(Optional) Bits per second (bps) will be used to determine the rate at which
traffic is policed.
Note
(Optional) Specifies the burst rate, in bytes, will be used for policing traffic.
Valid range is from 64 to 2,596,929,536.
(Optional) Specifies the peak burst value, in bytes, for the peak rate. Valid
range is from 32,000 to 32,000,000,000.
(Optional) Specifies the peak burst value, in bytes, will be used for policing
traffic. If the police rate is specified in bps, the valid range of values is 64 to
2,596,929,536.
(Optional) A percentage of interface bandwidth will be used to determine the
rate at which traffic is policed.
(Optional) Bandwidth percentage. Valid range is a number from 1 to 100.
(Optional) Burst rate, in milliseconds, will be used for policing traffic. Valid
range is a number from 1 to 2,000.
(Optional) A percentage of interface bandwidth will be used to determine the
PIR. Valid range is a number from 1 to 100.
(Optional) Peak burst rate, in milliseconds, will be used for policing traffic.
Valid range is a number from 1 to 2,000.
If a rate is not specified, traffic is policed via bps.
Chapter 2
Advertisement
Table of Contents
