Cisco Catalyst 4500 Series Configuration Manual page 746

show diagnostic content
show diagnostic content
To display test information about the test ID, test attributes, and supported coverage test levels for each
test and for all modules, use the show diagnostic content command.
Syntax Description all
num
Command Default This command has no default settings.
Command Modes EXEC
Command History Release
12.2(20)EWA
Examples The following example shows how to display the test suite, monitoring interval, and test attributes for
all the modules of the chassis:
Switch# show diagnostic content module all
module 1:
Diagnostics test suite attributes:
P/V/* - Per port test / Per device test / NA
D/N/* - Disruptive test / Non-disruptive test / NA
ID
==== ========================================== ============ =================
1) supervisor-bootup -----------------------> **D****I**
2) packet-memory-bootup --------------------> **D****I**
3) packet-memory-ongoing -------------------> **N****I*o
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-698
show diagnostic content module {all | num}
Displays all the modules on the chassis.
Module number.
Modification
This command was introduced on the Catalyst 4500 series switch.
B/* - Basic ondemand test / NA
S/* - Only applicable to standby unit / NA
X/* - Not a health monitoring test / NA
F/* - Fixed monitoring interval test / NA
E/* - Always enabled monitoring test / NA
A/I - Monitoring is active / Monitoring is inactive
m/* - Mandatory bootup test, can't be bypassed / NA
o/* - Ongoing test, always active / NA
Test Name
Testing Interval
Attributes (day hh:mm:ss.ms)
not configured
not configured
not configured
Chapter 2
OL-30934-01