Cisco Catalyst 4500 Series Configuration Manual page 924

show mac-address-table static
show mac-address-table static
To display the static MAC address table entries only, use the show mac-address-table static command.
Syntax Description address mac_addr
interface type number
protocol protocol
vlan vlan_id
Command Default
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(12c)EW
12.2(25)EW
Usage Guidelines For the MAC address table entries that are used by the routed ports, the routed port name is displayed in
the "vlan" column not the internal VLAN number.
The keyword definitions for the protocol argument are as follows:
•
•
•
•
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-876
show mac-address-table static [address mac_addr | interface type number | protocol protocol |
vlan vlan_id]
(Optional) Specifies a 48-bit MAC address to match; the valid format is
H.H.H.
(Optional) Specifies an interface to match; valid values for type are
fastethernet, gigabitethernet, and tengigabitethernet.
(Optional) Specifies a protocol. See the "Usage Guidelines" section for
more information.
(Optional) Displays the entries for a specific VLAN; valid values are from
1 to 4094.
Modification
This command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
Added support for the 10-Gigabit Ethernet interface.
assigned specifies the assigned protocol entries.
ip specifies the IP protocol.
ipx specifies the IPX protocols.
other specifies the other protocol entries.
Chapter 2
OL-30934-01