Cisco Catalyst 4500 Series Configuration Manual page 411
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
The ip wccp check services all command is a global WCCP command that applies to all services and is
Note
not associated with a single service.
Examples
The following example shows how to configure all WCCP services:
Router(config)# ip wccp check services all
Related Commands
Command
ip wccp
ip wccp group-listen
ip wccp redirect
ip wccp redirect exclude
in
ip wccp version
Description
Enables support of the specified WCCP service for participation in a service
group.
Configures an interface on a router to enable or disable the reception of IP
multicast packets for Web Cache Communication Protocol (WCCP).
Enables packet redirection on an inbound or outbound interface using Web
Cache Communication Protocol (WCCP).
Configure an interface to exclude packets received on an interface from
being checked for redirection.
Specifies which version of WCCP you wish to use on your router.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
ip wccp check services all
2-371
Advertisement
Table of Contents
