Ip Igmp Snooping Vlan - Cisco Catalyst 4500 Series Configuration Manual
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
ip igmp snooping vlan
To enable IGMP snooping for a VLAN, use the ip igmp snooping vlan command. To disable IGMP
snooping, use the no form of this command.
Syntax Description
vlan-id
Command Default
IGMP snooping is disabled.
Command Modes
Global configuration mode
Command History
Release
12.1(8a)EW
12.1(12c)EW
Usage Guidelines
This command is entered in VLAN interface configuration mode only.
The ip igmp snooping vlan command is disabled by default on multicast routers.
Examples
The following example shows how to enable IGMP snooping on a VLAN:
Switch(config)# ip igmp snooping vlan 200
Switch(config)#
The following example shows how to disable IGMP snooping on a VLAN:
Switch(config)# no ip igmp snooping vlan 200
Switch(config)#
Related Commands
Command
ip igmp snooping vlan immediate-leave
ip igmp snooping vlan mrouter
ip igmp snooping vlan static
ip igmp snooping vlan vlan-id
no ip igmp snooping vlan vlan-id
Number of the VLAN; valid values are from 1 to 1001 and from 1006 to 4094.
Modification
This command was introduced on the Catalyst 4500 series switch.
Support for extended addressing was added.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Enable IGMP immediate-leave processing.
Configures a Layer 2 interface as a multicast router
interface for a VLAN.
Configures a Layer 2 interface as a member of a group.
ip igmp snooping vlan
2-341
Advertisement
Table of Contents
