Debug Redundancy - Cisco Catalyst 4500 Series Configuration Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

debug redundancy

To debug supervisor engine redundancy, use the debug redundancy command. To disable the debugging
output, use the no form of this command.
Syntax Description
errors
fsm
kpa
msg
progression
status
timer
Command Default This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(12c)EW
Examples The following example shows how to debug the redundancy facility timer event debugging:
Switch# debug redundancy timer
Redundancy timer debugging is on
Switch#
debug redundancy {errors | fsm | kpa | msg | progression | status | timer}
no debug redundancy
Enables the redundancy facility for error debugging.
Enables the redundancy facility for FSM event debugging.
Enables the redundancy facility for keepalive debugging.
Enables the redundancy facility for messaging event debugging.
Enables the redundancy facility for progression event debugging.
Enables the redundancy facility for status event debugging.
Enables the redundancy facility for timer event debugging.
Modification
This command was introduced on the Catalyst 4500 series switch (Catalyst 4507R
only).
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
debug redundancy
2-177