Cisco Catalyst 4500 Series Configuration Manual page 942

show monitor
The following example shows how to display SPAN information for session 2:
Switch# show monitor session 2
Session 2
------------
Type : Remote Source Session
Source Ports:
Dest RSPAN VLAN:
Ingress : Enabled, default VLAN=2
Learning : Disabled
Switch#
The following example shows how to display the detailed SPAN information for session 1:
Switch# show monitor session 1 detail
Session 1
---------
Type
Source Ports
Source VLANs
Source RSPAN VLAN : Fa6/1
Destination Ports : Fa6/1
Filter VLANs
Filter Types RX : Good
Filter Types TX : None
Dest Rspan Vlan : 901
Ingress : Enabled, default VLAN=2
Learning : Disabled
IP Access-group : None
Switch#
The following example shows how to display SPAN information for session 1 beginning with the line
that starts with Destination:
Switch# show monitor session 1 | begin Destination
Destination Ports: None
Filter VLANs:
Switch#
Switch#
Related Commands Command
monitor session
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-894
RX Only: Fa1/1-3
901
: Local Session
:
RX Only : None
TX Only : None
Both : Gi1/1, CPU
:
RX Only : None
TX Only : None
Both : None
Encapsulation : DOT1Q
Ingress : Enabled, default VLAN = 2
: None
None
Description
Enables the SPAN sessions on interfaces or VLANs.
Chapter 2
OL-30934-01