Cisco Catalyst 4500 Series Configuration Manual page 752

show diagnostic result module test
show diagnostic result module test
To display the results of the bootup packet memory test, use the show diagnostic result module test
command. The output indicates whether the test passed, failed, or was not run.
Syntax Description N
all
test test-id
detail
Command Default Non-detailed results.
Command Modes
EXEC mode
Command History Release
12.2(25)SG
Usage Guidelines The detail keyword is intended for use by Cisco support personnel when analyzing failures.
Examples
The following example shows how to display the results of the bootup packet memory tests:
Switch# show diagnostic result module 6 detail
module 6:
Overall diagnostic result:PASS
Test results:(. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-704
show diagnostic result module [N | all] [test test-id] [detail]
Modification
This command was introduced on the Catalyst 4500 series switch.
1) linecard-online-diag --------------------> .
Error code --------------------------> 0 (DIAG_SUCCESS)
Total run count ---------------------> 1
Last test execution time ------------> Jan 21 2001 19:48:30
First test failure time -------------> n/a
Last test failure time --------------> n/a
Last test pass time -----------------> Jan 21 2001 19:48:30
Total failure count -----------------> 0
Consecutive failure count -----------> 0
(Optional) Specifies the module number.
(Optional) Specifies all modules.
(Optional) Specifies the number for the tdr test on the platform.
(Optional) Specifies the display of detailed information for analysis.
This option is recommended.
Chapter 2
OL-30934-01