Cisco Catalyst 4500 Series Configuration Manual page 489

Chapter 2
macsec network-link
To enable MKA MACsec on switch-to-switch links using EAP-TLS, use the macsec netowrk-link
command.
Syntax Description macsec network-link
Command Default
This command has no default settings.
Command Modes
Interface configuration mode
Command History Release
Cisco IOS XE 3.9.0E This command was introduced on Cisco Catalyst 4500-E with Supervisor
Usage Guidelines This command cannot be used to configure multi-point to multi-point links.
Examples
The following example shows how to enable the Cisco-recommended features and settings on port fa2/1:
Switch(config)# interface FastEthernet2/1
Switch(config-if)# macsec network-link
Switch(config-if)# exit
macsec network-link
Enables MKA MACsec on switch-to-switch links using Extensible
Authentication Protocol-Transport Layer Security (EAP-TLS) method.
Modification
Engine 8-E, and on Cisco Catalyst 4500-X series switches.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
macsec network-link
2-449