Installing The Rear Cover (Riser Module 2); Insert The Riser Module 2 (Hl); Concluding Steps; Replacing Expansion Cards In Riser Modules - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

9.5.4.5

Installing the rear cover (riser module 2)

Figure 111: Installing the rear cover
Ê Insert the rear cover.
Ê Fasten the rear cover with three screws (see circles and closeup).
9.5.4.6

Insert the riser module 2 (HL)

Optionally you can install the riser module. In this case proceed as follows:
Ê Install the riser module as described in section
(HL)" on page
9.5.4.7

Concluding steps

"Reassembling" on page 61
Ê
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
"Enabling BitLocker functionality" on page 92
Ê
RX2540 M1
200.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the riser module 2
205