Table of Contents
Advertisement
o Repeat the measurement.
1. Click
Executing Auto scale
Traces obtained after setting the sweep conditions and measurement parameters may
extend beyond the screen because they are too large or too small along the direction of the
vertical axis. In this case, the auto scale function can be used to set the appropriate scale.
Follow these steps to execute auto scale.
Step 1. Specify the trace (measurement parameter) for which you want to execute auto scale as the
active trace (Refer to Figure 3-9 and Figure 3-10).
Step 2. Click
Step 3. When it is necessary to execute auto scale for other trace numbers (measurement
parameters), repeat the above Steps 1 and 2.
NOTE
Clicking
Step 4. Select
toolbar.
Figure 3-59
Step 4
NOTE
The display of the setup toolbar can also be hidden by pressing the
the ENTRY/NAVIGATION block.
The measurement results, as shown in Figure 3-60, Figure 3-61, Figure 3-62 and Figure
3-63, can be obtained by executing auto scale for all traces by using the setup examples
described in "STEP 2. Setting Measurement Conditions" on page 45.
Chapter 3
STEP 8. Measuring DUT and Analyzing Measurement Results
on the
Continuous
Trigger
on the
menu to execute auto scale (Figure 3-54).
Autoscale
Scale
on the
Autoscale All
Scale
on the
menu (Figure 3-59) and hide the display of the setup
Toolbar Off
System
Basic Operations for RF Devices Measurement
menu.
menu executes auto scale for all traces.
key in
[Cancel/Close]
83
Advertisement
Table of Contents
