Table of Contents
Advertisement
Basic Operations for RF Devices Measurement
STEP 5. Setting Electrical Length
Step 3. After setting the electrical length, confirm that "Del 14m" is shown in the status bar on the
bottom of the screen (Figure 3-46).
Figure 3-46
Display of status bar when setting electrical length
NOTE
"Del xx" indicates Delay xx mm. This is a status display showing that the electrical length
of xx mm is set.
Table 3-9
Electrical lengths of standard test fixtures
Model
16191A
Electrical
14.0 mm
length
Procedure for Using Front Panel Keys
Step 1. Press the
Step 2. Set the electrical length by either of the following methods.
o Using the a fixture that is registered
o Using a test fixture that is made by the user
Step 3. After setting the electrical length, confirm that "Del 14m" is shown in the status bar on the
bottom of the screen (Figure 3-46).
72
16192A
16193A
11.0 mm
14.0 mm
key in the STIMULUS block.
[Cal/Compen]
Press the
or
key in the ENTRY/NAVIGATION block to move the cursor to the
Fixture Type box and then press the
key to move the cursor to model number of test fixture to be used and press the
3-44).
Press the
or
key to move the cursor to the
the
key to open the list. Press the
and press the
key
. Next,
box and
Fixture Length
input the electrical length with the numerical keys. When inputting
the electrical length of 14 mm, for example, press the
(Figure 3-45).
16196A
16196B
26.2 mm
26.9 mm
key to open the list. Then press the
Fixture Type
or
key to move the cursor to
press the
or
key to move the cursor to the
,
16196C
16197A
27.1 mm
14.0 mm
or
key (Figure
box and then press
User
,
keys in this order
Chapter 3
Advertisement
Table of Contents
