Setting The Measurement Points, Sweep Parameter And Sweep Type; Setting The Source Mode, Oscillator Level And Cw Frequency; Setting The Sweep Range (Dc Bias) - Agilent Technologies E4991A Installation And Quick Start Manual

Setting the Measurement Points, Sweep Parameter and Sweep Type

Step 1. Click
Step 2.
Number Of Points
Step 3. Select
Figure 3-24 Step 3
NOTE Setting sweep parameter to
Linear.

Setting the Source Mode, Oscillator Level and CW Frequency

Step 1. Click
Step 2. Select
Step 3. Select
Step 4. Select

Setting the Sweep Range (dc Bias)

Step 1. Click
Step 2.
Start
Step 3. Select
Figure 3-25 Steps 2, 3
Chapter 3
on the
Sweep Setup... Stimulus
box is set to
201
in the
Bias Current Sweep Parameter
Bias Current (Voltage)
on the menu (Figure 3-15).
Source... Stimulus
in the box (Figure 3-16).
Current Osc Unit
box and type
Osc Level [1] [m] [Enter]
box and type
CW Freq [1] [0] [0] [M] [Enter]
on the
Start/Stop... Stimulus
box is set to A in the initial state (Figure 3-25).
1 0 0 u
box and type
Stop [5] [0] [m] [Enter]
Basic Operations for RF Devices Measurement
STEP 2. Setting Measurement Conditions
menu (Figure 3-13).
in the initial state.
box (Figure 3-24).
automatically sets sweep type to
on the keyboard (Figure 3-17).
on the keyboard (Figure 3-22).
menu (Figure 3-18).
on the keyboard (Figure 3-25).
59