System Recovery; Types Of System Recoveries; Notes On Executing The Factory Recovery Function - Agilent Technologies ENA Series Service Manual

System Recovery

System Recovery
System Recovery
By executing system recovery, you can return the system of the E5061A/E5062A (the
Windows operating system and the firmware) to the factory state (at the time of
*1
purchase ).

Types of system recoveries

The following 2 types of system recoveries are available.
 Factory recovery
Returns the contents of the C drive to the factory state.
*2
 User recovery
Returns the contents of the C drive to a user-specified state. To use this function, you
must prepare for recovery in advance. For information on the preparation, see
"Procedure to create the user backup image" on page 208 for information on the
execution, see "Procedure to execute the user recovery function" on page 211.

Notes on executing the factory recovery function

Executing the factory recovery function causes the following:
 In addition to the Windows operating system and the firmware, the following settings
of the E5061A/E5062A are returned to the factory state or a user specified state.
• Network setting
• GPIB setting
• Printer setting
 The driver for the supported printer installed after purchase is deleted.
 You need to execute initial registration again.
Files you created using the save function (files in the D drive) are not affected, but we
recommend backing them up before executing system recovery for precautionary
purposes. For more information on backup, refer to "Making Backup Files" as described in
E5061A/E5062A User's Guide.
*1.If the hard disk failed and has been replaced after purchase, the state when the replacement
was performed is recovered.
*2.This function is available when the volume label on the hard disk is AL200 or higher.
204 Appendix B