Step 10. Click the
of the LOAD calibration data measurement, a √ mark appears on the left side of the
Load
Step 11. Click the
the measured calibration data and save it to the internal memory.
Step 12. Depending on the measurement points of the calibration data specified in the
box, the display below the
screen will change, as shown in the following table.
Table 4-4
Status display when calibration is completed
box
Cal Type
User Freq&Pwr
Fixed Freq&Pwr
FixedFreq,UserPwr
Chapter 4
button to start measuring LOAD calibration data. Upon completion
Meas Load
button.
button to instruct the E4991A to calculate the calibration coefficient from
Done
Cal Menu
Display below the
Cal Menu
Before
calibration
calibration
→
[Uncal]
→
[Uncal]
→
[Uncal]
Basic Operations for Dielectric Measurement
button and on the status bar at the bottom of the
button
Status bar on the bottom of the screen
After
Before
calibration
[User]
Uncal
[Fix]
Uncal
[FixR]
Uncal
STEP 6. Calibration
Meas
Cal Type
After
calibration
→
Cal User
→
Cal Fix
→
Cal FixR
119