Table of Contents
Advertisement
STEP 9. Changing Sweep Conditions
When the measurement points for calibration are user-defined frequency/user-defined
power points, start measurement with "STEP 3. Calibration" on page 60 after changing the
measurement conditions. When the measurement points for calibration are fixed
frequency/fixed power points, start measurement with "STEP 8. Measuring DUT and
Analyzing Measurement Results" on page 82.
NOTE
When the measurement points for calibration are fixed frequency/user-defined power
points, start measurement with "STEP 3. Calibration" on page 60 after changing the
oscillator level. When you change other sweep conditions, start measurement with "STEP
8. Measuring DUT and Analyzing Measurement Results" on page 82.
STEP 10. Measuring Other DUTs
If you measure another DUT of the same type and size as the one used in the previous
measurement, start measurement with "STEP 7. Connecting DUT to Test Fixture" on
page 81. If you use the same test fixture to measure a DUT of a different type and size, start
measurement with "STEP 6. Fixture Compensation" on page 73. When using a different
test fixture, start measurement with "STEP 4. Connecting Test Fixture" on page 70.
NOTE
When measuring a DUT in the initial state after turning the power ON, start measurement
with "STEP 2. Setting Measurement Conditions" on page 45.
Chapter 3
Basic Operations for RF Devices Measurement
STEP 9. Changing Sweep Conditions
103
Advertisement
Table of Contents
