Table of Contents
Advertisement
Table 2-1
Contents of E4991A package
Handle Kit (Option 1CN)
Rack Mount Kit (Option 1CM)
Rack Mount / Handle Kit (Option 1CP)
*1.Used when installing VBA on an external PC. "x" in the part number indicates firmware
*2.Includes a 0 S (OPEN), 0 Ω (SHORT), and 50 Ω (LOAD) standard and a low-loss
*3.Contains the contents of the Operation Manual, Quick Start Guide, Programming Man-
*4.This accessory is not shown in Figure 2-2. For the part number, refer to Figure 2-12 on
*5.Use this adapter when a GPIB cable is connected to the rear panel GPIB connector.
*6. "x" in the part numbers of manuals, and Sample Programs disk indicates edition or
*7.Includes a stand, a holder kit (two items), and four screws.
Figure 2-2
Standard contents of package
Chapter 2
Name of item
revision, with "0" for revision 1.00 and then increments of one for each subsequent revi-
sion. The latest revision is supplied with the product.
capacitor. Carrying case is not shown in Figure 2-2.
ual, and Sample Programs. "x" in the part numbers of CD-ROM indicates revision num-
bers, with "0" for the initial edition and then increments of one for each subsequent
edition. The latest editions are supplied with the product.
page 30.
revision numbers, with "0" for the initial edition and then increments of one for each
subsequent edition. The latest editions are supplied with the product.
Installation Guide
Incoming Inspection
Agilent product/
Quantity
part No.
1
5063-9229
1
5063-9216
1
5188-4430
19
Advertisement
Table of Contents
