Table of Contents
Advertisement
STEP 7. Connecting DUT to Test Fixture
The method of connecting the DUT (1608 (mm) / 0603 (inch) size) to the 16197A is
described as an example.
Step 1. Push the latch button while pressing the lever to set the DUT connection terminal of the
test fixture to the OPEN state.
Step 2. Remove the short device.
Step 3. Place the DUT in the same way as you placed the short device (Figure 3-50).
Step 4. Release the latch button while pressing the lever and then release the lever slowly.
Chapter 3
Basic Operations for RF Devices Measurement
STEP 7. Connecting DUT to Test Fixture
81
Advertisement
Table of Contents
