Table of Contents
Advertisement
Incoming Inspection
WARNING
To avoid dangerous electrical shock, do not turn the power on if any part of the
instrument's exterior (top cover, bottom cover, side covers, front panel, rear panel,
LCD display, connectors or line switch) appears to have been damaged during
shipment.
Inspect the equipment by following these steps while unpacking the contents of the
shipping container.
Figure 2-1
Flow for incoming inspection
Step 1. Confirm that the shipping container or cushioning material is not damaged.
Step 2. Confirm that all of the contents of the shipment are included in the package.
Step 3. Confirm that there exists no mechanical or electrical defect.
Step 4. Confirm that the E4991A operates normally both mechanically and electrically.
For a list of the package's contents, refer to Table 2-1. Figure 2-2 shows the contents of the
standard package that comes with the E4991A.
NOTE
If any of the contents of the package is missing or found to have mechanical damage or
defects, or if any failure is found during verification of equipment operation, inform the
nearest Agilent Technologies office. If the box is damaged or the cushioning materials
show signs of unusual stress, inform the transport company in addition to the Agilent
Technologies office. Keep the box, cushioning materials, and contents of the package as
you found them; these materials will need to be examined in their delivered condition
during the incoming inspection.
Chapter 2
Installation Guide
Incoming Inspection
17
Advertisement
Table of Contents
