Table of Contents
Advertisement
Basic Operations for Dielectric Measurement
STEP 3. Setting Measurement Conditions
Step 8. Specify Trace 3 as the active trace (* mark) and select
box.
Step 9. Select
Lin Y-Axis
Setting the Measurement Points, Sweep Parameter, and Sweep Type
Step 1. Click
Sweep Setup...
Step 2. In the
Number Of Points
want to enter 301, type
Step 3. Select
Frequency
Step 4. Select
in the
Log
Setting the Source Mode and Oscillator Level
Step 1. Click
on the
Source...
Step 2. Select
in the
Voltage
Step 3. In the
Osc Level
type
[1] [0] [0] [m] [Enter]
Setting the Sweep Range (Frequency)
Step 1. Click
Start/Stop...
Step 2. In the
box, enter the start frequency. For example, if you want to enter 1 MHz, type
Start
with the keyboard.
[1] [M] [Enter]
Step 3. In the
box, enter the stop frequency. For example, if you want to enter 1 GHz, type
Stop
with the keyboard.
[G] [Enter]
112
in the
box.
Format
on the
menu.
Stimulus
box, enter the desired measurement points. For example, if you
with the keyboard.
[3] [0] [1] [Enter]
in the
Sweep Parameter
box.
Sweep Type
menu.
Stimulus
box.
Osc Unit
box, enter the oscillator level. For example, if you want to enter 100 mV,
with the keyboard.
on the
menu.
Stimulus
from the
tanδ (ε)
box.
Meas Parameter
[1]
Chapter 4
Advertisement
Table of Contents
