Table of Contents
Advertisement
Procedure for Using Front Panel Keys
Set up the E4991A as shown in the following procedure.
Presetting the E4991A
Step 1. Press the
key in the SYSTEM block to return to the initial state.
[Preset]
Setting the Measurement Parameters and Display Formats
Step 1. Press the
[Display]
Step 2. Press the
or
the
key to open the list. Next, press the
and press the
Scalar
Step 3. Press the
[Meas/Format]
Step 4. Press the
key in the MEASUREMENT block to specify Trace 1 as the active
[Trace]
trace. When the trace is made active, "*" appears before Trace 1.
Step 5. The
Meas Parameter
Step 6. Press the
or
the
box and then press the
Format
key to move the cursor to
Step 7. Press the
key in the MEASUREMENT block to specify Trace 2 as the active
[Trace]
trace.
Step 8. Press the
or
the
key to open the list. Next, press the
and press the
Step 9.
box is set to
The Format
Step 10. Press the
key in the MEASUREMENT block to specify Trace 3 as the active
[Trace]
trace.
Step 11.
The Meas Parameter
Step 12.
box is set to
The Format
Setting the Measurement Points, Sweep Parameter and Sweep Type
Step 1. Press the
key in the STIMULUS block.
[Sweep]
Step 2.
The number Of Points
Chapter 3
Basic Operations for RF Devices Measurement
STEP 2. Setting Measurement Conditions
key in the MEASUREMENT block.
key to move the cursor to the
key (Figure 3-7).
key in the SYSTEM block.
box is set to
in the initial state.
|Z|
key in the ENTRY/NAVIGATION block to move the cursor to
key to open the list. Next, press the
and press the
Log Y-Axis
key to move the cursor to the
key (Figure 3-12).
in the initial state.
Lin Y-Axis
box is set to
in the initial state.
Q
in the initial state.
Lin Y-Axis
box is set to
in the initial state (Figure 3-14).
201
box, and then press
Num Of Traces
or
key to move the cursor to
key (Figure 3-11).
box and then press
Meas Parameter
or
key to move the cursor to
3
or
Ls
51
Advertisement
Table of Contents
