Table of Contents
Advertisement
Figure 4-3
Required equipment
Connecting Mouse, Keyboard, and Test Head
Connect the mouse, keyboard and test head to the E4991A by referring to "Connection to
Rear Panel" on page 27 and "Connecting the Test Head" on page 28. Be sure not to remove
the four feet on the bottom of the E4991A when connecting the test head.
NOTE
Be sure to connect the mouse and keyboard before turning the power ON.
Turning the Power ON
Perform the following steps to turn the power ON. The E4991A starts a self-test
automatically when the power is turned ON.
Step 1. If the standby switch (
position, press it to put it in the popped up position (
Step 2. Press the standby switch to the depressed position (
NOTE
Special caution is required when turning the power ON or OFF. Refer to "Turning the
Power ON and OFF" on page 31
Chapter 4
Basic Operations for Dielectric Measurement
STEP 1. Preparation for Measurement
) in the lower-left part of the front panel is in the position (
.
).
).
109
)
Advertisement
Table of Contents
