Agilent Technologies E4991A Installation And Quick Start Manual page 40

Basic Operations for RF Devices Measurement
Contents of this
chapter
o Impedance Measurement Overview page 41
o STEP 1. Preparation for Measurement page 43
o STEP 2. Setting Measurement Conditions page 45
o STEP 3. Calibration page 60
o STEP 4. Connecting Test Fixture page 70
o STEP 5. Setting Electrical Length page 71
o STEP 6. Fixture Compensation page 73
o STEP 7. Connecting DUT to Test Fixture page 81
o STEP 8. Measuring DUT and Analyzing Measurement Results page 82
o STEP 9. Changing Sweep Conditions page 103
o STEP 10. Measuring Other DUTs page 103
40
Measurement examples and a basic flow for impedance measurement.
How to prepare for measurement.
How to set sweeping conditions and measurement parameters.
How to perform OPEN / SHORT / LOAD (/ LOW-LOSS CAPACITOR)
calibrations.
How to connect the test fixture (16197A) to the 7-mm terminal of the test head.
How to set the electrical length for the test fixture.
How to perform OPEN/SHORT compensation. OPEN/SHORT compensation
for the 16197A is explained as an example.
How to connect a DUT to the test fixture (16197A).
How to achieve the optimum setting of the vertical axis scale and analyze the
measurement results.
How to change the sweep conditions.
How to measure other DUTs.
Chapter 3