Table of Contents
Advertisement
Basic Operations for RF Devices Measurement
STEP 1. Preparation for Measurement
Figure 3-3
Required equipment
Connecting Mouse, Keyboard and Test Head
Connect the mouse, keyboard and test head to the E4991A as shown in "Connection to
Rear Panel" on page 27 and "Connecting the Test Head" on page 28. Be sure not to remove
the four feet on the bottom of the E4991A when connecting the test head.
NOTE
Be sure to connect the mouse and keyboard before turning the power ON.
NOTE
Do not connect the test fixtures to the test head at this point because calibration is
performed on the DUT port (7-mm terminal) of the test head later.
Turning the Power ON
Perform the following steps to turn the power ON. The E4991A starts the self-test
automatically when the power is turned ON.
Step 1. If the standby switch (
(
Step 2. Press the standby switch to put it in the pressed down position (
NOTE
Special caution is required when turning the power ON or OFF. Refer to "Turning the
Power ON and OFF" on page 31
44
) in the lower-left part of the front panel is in the depressed
) position, press the switch to put it in the popped up position (
.
).
).
Chapter 3
Advertisement
Table of Contents
