Table of Contents
Advertisement
Basic Operations for RF Devices Measurement
STEP 2. Setting Measurement Conditions
Step 3.
The Sweep Parameter
Step 4. Press the
or
key to open the list. Next, press the
press the
key (Figure 3-14).
Setting the Source Mode and Oscillator Level
Step 1. Press the
[Source]
Step 2. Press the
or
key to open the list. Next, press the
and press the
Step 3. Press the
or
,
keys in this order (Figure 3-17).
Setting the Sweep Range (Frequency)
Step 1. Press the
[Start/Stop]
Step 2. The
box is set to
Start
Step 3. The
box is set to
Stop
52
box is set to
Frequency
key to move the cursor to the
key in the STIMULUS block.
key to move the cursor to the
key (Figure 3-16).
key to move the cursor to the
key in the STIMULUS block.
Hz in the initial state (Figure 3-19).
1 M
Hz in the initial state (Figure 3-19).
3 G
in the initial state (Figure 3-14).
box and then press the
Sweep Type
or
key to move the cursor to
box and then press the
Osc Unit
or
key to move the cursor to
box and then press the
Osc Level
and
Log
Current
Chapter 3
Advertisement
Table of Contents
