System Recovery; Types Of System Recoveries; Notes On Executing The Factory Recovery Function - Agilent Technologies E5071C Service Manual

System Recovery

System Recovery
System Recovery
By executing system recovery, you can return the system of the E5071C (the Windows
operating system and the firmware) to the factory state (at the time of purchase
CAUTION Strictly follow the steps described below. If you do any operation other than the following
steps, the system may not be recovered.

Types of system recoveries

The following 2 types of system recoveries are available.

Notes on executing the factory recovery function

Executing the factory recovery function causes the following:
Files you created using the save function (files in the D drive) are not affected, but we
recommend backing them up before executing system recovery for precautionary
purposes. For more information on backup, refer to "Backing Up the Data" as described in
E5071C Online Help.
336
Factory recovery
Returns the contents of the C drive to the factory state.
User recovery
Returns the contents of the C and D drives to a user-specified state. To use this
function, you must prepare for recovery in advance. For information on the
preparation, see "Procedure to create the user backup image" on page 340 for
information on the execution, see "Procedure to execute the user recovery function" on
page 346.
In addition to the Windows operating system and the firmware, the following settings
of the E5071C are returned to the factory state or a user specified state.
• Network setting
• GPIB setting
• Printer setting
The driver for the supported printer installed after purchase is deleted.
You need to execute initial registration again.
*1.If the hard disk failed and has been replaced after purchase, the state when the replacement
was performed is recovered.
*1
).
Appendix B