To Do The Incoming Inspection - Agilent Technologies 89410A Getting Started Manual

Preparing the Analyzer for Use

To do the incoming inspection

The Agilent 89410A DC-10 MHz Vector Signal Analyzer was carefully inspected
both mechanically and electrically before shipment. It should be free of marks
or scratches, and it should meet its published specifications upon receipt.
1
Inspect the analyzer for physical damage incurred in transit. If the analyzer
was damaged in transit, do the following:
l
l
l
Warning
If the analyzer is mechanically damaged, the integrity of the protective
earth ground may be interrupted. Do not connect the analyzer to
power if it is damaged.
2
Check that the line-voltage selector switch on the analyzer's rear panel is set
for the local line voltage.
The line-voltage selector switch is set at the factory to match the most
commonly used line voltage in the country of destination. To change the
line-voltage selector switch, see ''To set the line-voltage selector switch.''
3
Check that the correct line fuse is installed in the fuse holder.
The fuse is installed at the factory for the most commonly used line voltage in
the country of destination. An 8 amp, 250 volt, normal blow fuse is required if
the selector switch is set at 115 and a 4 amp, 250 volt, normal blow fuse is
required if the selector switch is set at 230. For instructions on removing the
fuse or fuse part numbers, see ''To change the fuse.''
4
Using the supplied power cord, plug the analyzer into an appropriate receptacle.
The analyzer is shipped with a three-conductor power cord that grounds the
analyzer when plugged into an appropriate receptacle. The type of power cable
plug shipped with each analyzer depends on the country of destination.
Save all packing materials.
File a claim with the carrier.
Call your Agilent Technologies sales and service office.
7-5