Default Users And Passwords; Changing Default Passwords - 3Com SUPERSTACK 3 3870 Series Getting Started Manual

46 C 3: S
HAPTER ETTING
Default Users and
Passwords
Changing Default
Passwords
U M
P FOR ANAGEMENT
To manage your Switch using an SNMP network management
application, you need to specify SNMP community strings for the users
defined on the Switch. You can do this using the command line interface
system management snmp community command — refer to the
command line interface section of the "Management Interface Reference
Guide" for more information.
If you intend to manage the Switch using the web interface or the
command line interface, or to change the default passwords, you need to
log in with a valid user name and password. The Switch has three default
user names, and each user name has a different password and level of
access. These default users are listed in
CAUTION: To protect your Switch from unauthorized access, you must
change all three default passwords as soon as possible, even if you do not
intend to actively manage your Switch
Table 10 Default Users
User Default
Name Password Access Level
monitor monitor
manager manager
admin (no
password)
Use the admin default user name (no password) to login and carry out
initial Switch setup.
You can change the default passwords using either:
The gettingStarted command on the CLI, or
■
The security device user modify command on the CLI, or
■
The Security > Device > User > Modify operation on the web interface.
■
For more information about default users and passwords, refer to the
"Management Interface Reference Guide" on the Switch CD-ROM.
Table
monitor — the user can view all manageable parameters,
except special/security features, but cannot change any
manageable parameters.
manager — the user can access and change the
operational parameters but not special/security features
security — the user can access and change all manageable
parameters
10.