Manually Configuring The Network Ip Addresses - Teledyne T700 Operation Manual

Communications Setup and Operation

5.4.1.1. Manually Configuring the Network IP Addresses

184
There are several circumstances when you may need to manually set the Ethernet
configuration:

Your LAN is not running a DHCP software package,

The DHCP software is unable to initialize the calibrator's interface;

You wish to configure the interface with a specific IP address, such as for a
permanent Ethernet connection..
Manually configuring the Ethernet interface requires that you first turn DHCP to OFF
before setting the
MASK parameters:
Teledyne API – Model T700 Dynamic Dilution Calibrator
INSTRUMENT IP,
and
GATEWAY IP
06873B DCN6388
SUBNET