Table of Contents
Advertisement
Jumper Setting
6.1
See the User's Guide.
DISK LED Connector
6.2
Use this connector when installing an additional disk array controller.
See the User's Guide.
Temperature Sensor
6.3
This server is equipped with a temperature sensor that suppresses booting and sends notifications to
ESMPRO while monitoring the temperature on each board. For the sensor location, see the mother
board diagram earlier in this document.
7
BIOS Setting
The NEC logo is displayed by the default setting of BIOS during execution of POST. (This is not to
show users the POST screen according to the PC97 specification) If the system detects an error during
execution of POST, the screen changes to the POST screen that shows the error information.
The screen can be selected by SETUP.
To start BIOS SETUP, press F2 during execution of POST. Select the menu by using the arrow keys,
select the item you want to change, and set a new value. For details on SETUP, see the User's Guide
provided with the server.
8
Console redirection
To select the console redirection function, change the CRS (Console Redirection Switch) on the rear of
the server. The Console output can be changed to Serial or LAN depending on the BIOS setting. To use
the remote console with a software program other than MWA, start the BIOS Setup utility and specify
the serial port to which a console is connected.
Select [Server] → [Console Redirection] → [BIOS Redirection Port] → [Serial 1 (DB-9)] or [Serial 2
(RJ45)]. Set the same parameter for [Server] → [Console Redirection] → [ACPI Redirection].
See the User's Guide.
29 Service Guide
Advertisement
Table of Contents
