Loop - Vexta EMP400 Series Operating Manual

LOOP

Name Set a loop
Valid mode -/Program
Syntax LOOP [, |
n
Function Program iterates for the specified number of times between this command and the ENDL
command.
If the program control had been transferred into the LOOP-ENDL section from outside the
loop by means of a JMP command or a CJMP command, the loop will not be iterated and
stop. If the control is transferred from within the loop to the outside, the nesting level will be
cleared.
Loops can be nested up to four times.
Request -
Note
For each LOOP command, always set one ENDL command.
] n
Parameter
Number of iterations 1 to 99
8 Program command
Data range Default
8-29