List Of Messages Associated With Program - Vexta EMP400 Series Operating Manual

6.7
List of messages associated with
programming
The messages listed below may be displayed while writing, editing, downloading or uploading a
program.
An error message will appear if any invalid command or parameter is entered while editing a
program.
If an error message is displayed, go back to enter the A, I or D command again.
Can not Overwrite
>> Command:
Completed.
Delete line n (Y/N)?
Empty...Direct Insert Mode. (ESC/Q = exit)
End "TEXT CAPTURE"
Insert line n
Invalid value.
Line does not exist.
Press ENTER key.
Select: Ax, Ix, or Dx (Alt/Ins/Del/Q = exit)
Select upload Sequence No. 0-31, 99, A
(0-31, 99, ALL)?
Start DOWNLOAD
Start "TEXT CAPTURE"
Syntax error.
Message
6 Writing and editing a program
Description
You cannot overwrite an existing program.
Enter a command.
Downloading/uploading has been completed.
The nth line will be deleted.
The program is empty. A new program may be written.
Stop Text Capture of HyperTerminal.
The nth line will be inserted.
An invalid parameter has been entered for the command
you want to change or insert.
The line you want to change/insert/delete does not exist.
Press the Enter key.
Select the command for editing.
Select the program you want to upload.
Start sending the text file via HyperTerminal.
Start Text Capture of HyperTerminal.
The command you want to change or insert is invalid.
6-25