7.3
Automatic program execution
If a program is written under program number 99 (CONFIG program), program 99 will be automatically
executed upon power on or RESET command input.
Note
Inputting the operation command to sequence program 99 will cause the equipment to move abruptly
upon power on or RESET command input. Take safety considerations when writing a program for
program number 99.
1. See section 6.3, "Starting and exiting HyperTerminal," to connect the controller with a PC and
start HyperTerminal.
2. Type in "EDIT 99."
You can now write program 99.
3. Write or edit the program.
For details on program composition and editing, see 6, "Writing and editing the program."
7 7 7 7 7 Executing the program
7-7