Vexta EMP400 Series Operating Manual page 91

ID
Name Set ID
Valid mode Direct input/program
Syntax ID(1 | 2)[, |
Parameter
(1 | 2)
n
Function By entering the ID of the linear motion product, initialization of the controller corresponding
to the linear motion product will be performed. The parameters that will be initialized are
VS, V, SEN, OFS, ACTL and UNIT. To reset the values to the factory default setting, enter
the initial values.
When the ID is set, the current position data is cleared.
Request 0>ID1
0: ID1 = 10103000100000
]n
Axis 1 (select axis 1), 2 (select axis 2)
∗ If this parameter is omitted,
axis 1 will be selected.
ID 14 digits
8 Program command
Data range Default
10103000100000
8-25