Vexta EMP400 Series Operating Manual page 48

6 Writing and editing a program
10. Click on "Start."
The HyperTerminal screen appears.
11. Press the Enter key.
The controller begins uploading the program.
Once uploading is complete, a message (End "TEXT CAPTURE") appears.
Note
Do not use the keyboard while the program is being uploaded.
Doing so may result in an upload error.
12. Select "Capture Text" from the "Transfer" menu of HyperTerminal, then select "Stop."
This ends the Text Capture function.
13. Press the Enter key.
The "0>" command prompt is displayed.
14. Open the text file you saved and check to see that the program has been uploaded correctly.
If you try to save a new program to an existing text file, the program will be added and saved at the end of that text
file.
If you try to save a program under an existing program
number within the same text file, the new program will be
added and saved at the end of the existing program.
However, if you download this text file to the controller, the
first program will be enabled and the latter program will be
deleted.
6-16
The leading program is downloaded
(the remaining programs are deleted).
The same program
numbers are written.