Names Of Parts - Vexta EMP400 Series Operating Manual

3.2

Names of parts

This section covers the names and functions of parts in the controller.
Modular connector (CN2)
Used to connect the cable for
communication with terminals
such as a PC and operational
unit.
AXIS 1 connector (CN3)
Used to connect the first
axis I/O and sensor.
AXIS 2 connector (CN4)
Used to connect the second
axis I/O and sensor.
∗Only
3 3 3 3 3
Preparations
POWER LED
Lit when the power is on.
ALARM LED
Lit when an alarm event occurs.
I/O connector (CN1)
Used for external-signal and
general-purpose inputs and outputs.
Terminal block (TB1)
Used to connect the 24VDC
power supply and frame ground.
3-3