Table of Contents
Advertisement
MSD-501/502/701/702 User's Guide
7.13.1 Registering/editing control command
Menu
Top→PRESET COMMAND→COMMAND EDIT
Setting for
Each command
Setting value [Table 7.11] Setting value of control command
You can create and edit up to 32 control commands.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
Setting
Item
COM
PORT
yes
COM SIZE
yes
DELAY
yes
Communicati
yes
on port
COMMAND
yes
INPUT MODE
Send
yes
command
data
74
[Table 7.11] Setting value of control command
CEC
Select "COM" or "CEC".
yes
no
Set the number of bytes to be sent starting with
the first byte.
Set the waiting time of the control command.
yes
Use this item for devices such as projectors that
requires time to cool down after powering off.
Set the following communication ports to "OFF"
no
(not sending communication commands) or
"ON" (sending communication commands).
Those ports can be set separately, and
communication commands can be sent to
multiple communication ports at the same time.
*5
・RS:RS-232C
・OUT1B RS: RS-232C of OUT1B
・OUT2B RS: RS-232C of OUT2B
・LOOP BACK: Internal loop back
・LAN1 to LAN8: LAN connection 1 to 8
Set the input mode of send command data.
no
Select "ASCII" if "DATA" of "COMMAND"
consists of only 0A, 0D, and 20 to 7D of ASCII
codes. Select "HEX" if "DATA" of "COMMAND"
includes other codes.
Set the command from the first byte according
no
to the number of bytes set in "COM SIEZE" (up
to 30 bytes).
Description
*6
Range
COM: Communication
command [Default]
CEC: HDMI CEC control
0BYTE to 30BYTE
[Default]: 0BYTE
0ms to 999s999ms
[Default] 0ms
OFF [Default]
ON
ASCII [Default]
HEX
0A, 0D, 20 to 7D in
ASCII,
00 to FF in hex
[Default]: 20 (space)
Advertisement
Table of Contents
